Black WeeksZero Pro €39 €79Claim offer →
TOMMY

Mesh Networks

TOMMY Zero works on mesh Wi-Fi out of the box. There is nothing to configure.

Nothing to set up

A mesh Wi-Fi network has several access points, often called nodes, that share one network name. TOMMY Zero needs every device in a zone on the same access point, and it takes care of that for you. Flash your devices with your normal network name and password, and TOMMY Zero handles the rest.

Each zone shows the access point it uses in its header, with every device's signal to it.

Settings

Access point sync is Automatic by default, and most homes never need to change it. To choose the access point yourself, open Settings on the zone's access point card and pick Manual. TOMMY Zero then always uses the one you picked. If a device cannot connect to it, sensing stops for the whole zone until it can.

Synchronizing

The zone shows Synchronizing in the dashboard while its devices move to the same access point, and sensing pauses. This usually takes less than a minute, for example after a power cut or after a device joins the zone.

When synchronization fails

If no access point reaches every device in the zone, sensing stays stopped and the dashboard shows Synchronization failed. Open More details to see which device hears which access point, so you can see which devices to move or give a zone of their own. TOMMY Zero keeps trying by itself, so a node that was restarting is picked up again. You can also click Try again now.

Router zones

In a router zone the access point is part of the sensing, so the device stays on the router you choose. If the device ends up on another node, sensing pauses until it is back, so presence in another room is never reported for the zone.